Back to Home | Workbench 2.x Guide Contents | Site Map
If you have quit WinUAE after chapter 2 then re-launch the program, left click the config you made and click the Load button. Also you need the Magic Workbench.adf which can download from Here
N.B. This file is a ziped adf.
1. When the above file has been downloaded, load winuae as usual and
load the wb3.1 config you made and start emulation.
2. After Workbench has booted press F12 and go to floppies/disk
drives Properties and on the DF0: slot click the ‘...’ button on the right
and select Magic Workbench.adf image. Then Click Start (OK in older versions of Winuae)
to return to emulation.
3. Double click MagicWB and then double click Unpack MagicWB.
4. When asked, would you like to Unpack MagicWB? type Y and press Return/Enter.
5. When you see, Please enter path: type in Work:/ and press Return/Enter.
6. When all files have been extracted press Return/Enter, type endcli and press Return/Enter.
7. Double click Work and then double click on MagicWB.
8. Double click on Install.
9. When Install window opens press Return/Enter
10. When asked, Start the installation? type Y and press Return/Enter.
11. When asked, Do you want to have the HardDisk-Icon to other partitions? type Y and press Return/Enter.
12. When you see, Please enter the DEVICE NAME of your desired partition: type Work: and press Return/Enter. (repeat step 11 and 12 if you have more partitions)
13. When asked, Do you want to have the HardDisk-Icon to other partitions? type N and press Return/Enter.
14. When asked, Do you have a SYQUEST? type N and press Return/Enter.
15. When asked, Which Prefs draw should be installed? either type BIG or type SMALL and press Return/Enter. (I would type in SMALL)
16. Press Return/Enter about 6 times until you see 1> and then type endcli and press Return/Enter to exit install.
17. Double click System2.0, double click on Prefs and then double click on ScreenMode.
18. Drag the Colours: to the 8 setting and click Save.
19. Now restart the Amiga by holding down the 3 keys to finish setup. CTRL + INSERT + HOME, or in newer versions of WinUAE press CTRL + LEFT WINDOW + RIGHT WINDOW keys. (Or, In WinUAE 0.8.26, you could just press F12 then click reset on bottom left)
Back |